LED lighting fixtures installation specifications

Time：2015-09-15　Views：2319　Compile：SUNPER

LED lighting fixtures included in the package, please read the instructions carefully before installation, and follow installation requirements for operating instructions. If it found discrepancies with the description in place, please contact with the factory engineers to obtain solutions as soon as possible.

1. Fixtures should be paid attention to place softly when installed, forbidden the action to pull the wires out the fittings.

2. The lamps must be securely installed. With the help of the mounting holes on the fixtures, installation accessories, they are solid and reliable scheduled for the mounting surface. The lamp can withstand at least 10 times the weight of the fixture itself, when installation completed.

3. Glues can not be used for the mounting surface when fixtures installed, this is mainly because the lamp itself there will be heated, which will lead to decreased adhesion gum damage, destroying and falling down the lamp.

4. Take notice that the bottom of fixture should fits the surface of installation and less space would be suitable when the fixtures installed in the high-level building, in case of being blew up by the wind.

5. Ventilation and dispersion should be took into account as factors when choosing installation site. Confined environment and slick place should be ignored.   

6. Choose the application according the IP Grade of lamp, specific reference is based on the national standard IP Protection class requirements.

7. For lamps with waterproof joint, should pay attention to the protection of waterproof connector, avoid dust, water from entering, do not lose and destroy the rubber seals waterproof connector. Moreover, can not take other measures such as the use waterproof connectors specified in the instructions to cut outside, if special circumstances, which should be approved by the manufacturer.

8. Lamp with a waterproof connector, the signal is transmitted directivity, male socket as Input side, female socket as output side. Do Keep ensure that the wires of lamps not crushed by the screws and installation fittings, avoiding the shortcut, leakage and open circuit when installing the fixtures.

9. When light outlet to junction box or to a bare section of the bus using a yellow wax tubes or soft metal tube and so well protected to avoid outlet (Teflon wire, PVC wire, etc.) by the sun aging cracking.

10. All the constant voltage switching power supplies, isolated converter used outdoors should be placed on prevention water-electrical box and kept good heat dissipation. All controllers should be placed on the electrical box (make sure to waterproof outdoor type), the size of control box must be reasonable, which occupies an area of equipment should not exceed 1/2 of the total area, in order to carry out the operation and maintenance of the controller.

11. Control box device should be well marked distinction. Electrical wiring diagram should be attached inside the box.

12. All products (controllers, lighting, power supply, etc.) are required to configure or miniature circuit breaker socket (control box, electrical box), and other interruption control equipment, for maintenance, repair and use.

13. Projects related to the cable, conduit, cable tray, tape and other products through the country must be certified products by national labs, and all products must be flame retardant products (fire-retardant label).

14. During construction process, to avoid lines, embedded parts less cloth, drain cloth and so on.

15. Keep a professional electrical engineer in charge of the construction site when it is under construction, electrical engineering Engineers must be fully familiar with the site conditions, in order to meet our engineers post-commissioning.

16. Lighting and lightning protection systems must be kept away between lighting and systems, the signal line should have a good shielding and reliable ground, to avoid damage to lamps and systems of lighting.

More Posts

■ LM79 and LM80 Differences Explained

■ Color Temperature and Its Importance

■ The Color Rendering Index CRI