Lighting Education

Your current location: home > Blog

Production steps of the high power LED flood lamp

Time:2015-09-11 Views:2865 Compile:SUNPER


To begin with, a good manufacturing process should lead to a clean, generous as well as beautiful lamp. Each of the steps involved in this process is usually very important in the LED flood lamp.


The first step is about the light source aluminum welding in the corresponding plate. In this step, one needs to just pay attention to the local lamp beads in contact with the aluminum plate. It should be coated using suitable thermal silica. Both the negative and positive diode lamp beads with the aluminum plate should be firm by welding. If it is not weld at this step, it may bring some troubles to you later.


The second step in the LED flood lamp processing involves fixing the aluminum plate in the corresponding position of the lamp housing. The placement of the aluminum means that the results of the whole lamp luminous should be uniform. Most preferably, the position corresponding with the screws should make a full contact with the bottom surface of the lamp body as well as aluminum plate. The most important thing in this step is to pay attention to the aluminum plate and keep the lamp off the contact and also coat it using the most appropriate thermal silica.


The third step depends on the number of lamp beads, voltage, color and selecting the necessary drive power. The most suitable power supply may also increase the lifespan of the lamp. The cooling effect of the lamp is somehow linked with the drive.


The fourth step involved in the processing steps of the high power LED flood lamp is the placement of the lens, stent, aging and test. You must consider all these when using a small screw to secure the bottom surface of the bracket holder in full contact with the aluminum plate. This helps to prevent the inflow of the silicone stents in the next life of the lamp. The aging process can be portioned around ten minutes off the time and thus test the drive power of the life.


The fifth step is about the silicone. This is due to the fact that the whole luminaries can better aesthetics. You may select either black or white of the 2 different silica depending on the color of the lamp body. The sixth step involves installing the tempered glass surface cover. It should also be coated with the waterproof silicone.


The last step in the production of the LED flood lamp is about aging which is more than 24 hours. However, there are so many other details involved but the above ones are the most crucial ones in ensuring the overall quality of LED flood lamp.



More Posts

■ LED Floodlights Heat Sink Selection

■ What to check to know a LED Floodlight is good or bad

■ Various Benefits For LED Flood Lighting Options

User comments

Your current input 0 characters(Reply for at least 6 characters)。

Online Services

livechat

Mobile: +86 18938902515 (Mr.Allen)

Tel:+86 755 23159099

Fax:+86 755 61673151

E-mail: sales@sunper.net

zip code: 518108

Quick Messge